Use with adapter CA51 Rated input voltage: 100–240V AC, 50/60Hz 0.2A Max Rated output: 6.0V DC 70mA OPERATION 1. SAVE THESE INSTRUCTIONS OPERATING INSTRUCTIONS Before using the Class 2 Power Supply, read these instructions carefully. Do not use the appliance outdoors or where aerosol (spray) products are being used or oxygen is being administered. Before each use, make certain the blades are aligned properly and oiled. Do not use the appliance with a damaged or broken comb or with teeth missing from the blades, as injury may result. Do not place the appliance on any surface while it is operating. Never drop or insert any object into any opening of the appliance. Do not pull, twist or wrap the cord around the appliance. Keep the appliance cord away from heated surfaces. Return the appliance to a Conair Service Center for examination and repair. Never operate the appliance if it has a damaged cord or plug, is not working proper- ly, has been dropped or damaged, or dropped into water. Do not use an extension cord to operate the appliance. Use only attachments recommended by the manufacturer. Use appliance only for its intended use as described in this manual. This appliance should not be used by, on, or near children or individuals with certain disabilities. Never leave a plugged-in appliance unattended. DO NOT throw the battery into the normal municipal waste system. Bring the battery to the nearest collection center for proper disposal. Remove the bottom housing and cut the battery out. Using a small Phillips head screwdriver, remove the screws at the back of the trimmer. Replace with new cutting system and reverse the removal procedure, only this time place your thumb on the large cutter and snap into place. Remove the blade set by placing thumb against the smaller cutter and pushing for- ward, releasing the cutter assem- bly from the trimmer housing. CARE OF YOUR TRIMMER REPLACEMENT (REMOVAL) OF BLADE SET To remove blade set from your trimmer, make sure the trimmer is in the OFF position. ON/OFF SWITCH To operate, simply slide switch toward blade to stop, slide switch away from blade. After your mustache has been trimmed to the desired length, remove the 5-position comb and, using the blade only, define the outline of the bottom of your mustache. (You can always go back and cut your mustache more closely with a shorter setting.) Always trim your mustache from the top down. It is a good idea to start with the longest trim setting adjustment. Place the 5-position comb over the facial hair blade and snap it into position. Comb through your mustache in the direction it grows. For best results, start with a clean, slightly damp mustache. / MUSTACHE Instruction Booklet For your safety and continued enjoyment of this product, always read the instruction booklet carefully before using.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |